Numerical study on thermal performance of TiO2, Fe3O4 and NiCr/engine oil in an inclined wavy pip

The essential intention of the existing article is to illustrate the effect of wall properties on flow and thermal behavior, through a sinusoidal inclined wavy pipe. To succeed this phenomena we assume a sinusoidal pipe consist of wavy surface, whose walls traveling down to its borders and located at an inclined position, moreover titanium dioxide (TiO₂), ferrosoferric oxide (Fe₃O₄) and nichrome (80% Ni and 20% Cr) are considered as nano-particles and unused engine oil is assumed as a base fluid. The arising mathematical equations for thermal and flow ratio with wall slip impact are solved by mathematica. Also, evaluate graphically the thermal and flow behavior of nanofluids for multi values of solid volume fractions (η), rigidity parameter (M₁), stiffness parameter (M₂), viscous damping parameter (M₃), Grashof number (G_r), slip parameter (β) and heat generation parameter (H) also discuss the streamlines for different values of solid volume fraction.     

Prediction of the drag reduction effect of pulsating pipe flow based on machine learning

Prediction of drag reduction effect caused by pulsating pipe flows is examined using machine learning. First, a large set of flow field data is obtained experimentally by measuring turbulent pipe flows with various pulsation patterns. Consequently, more than 7000 waveforms are applied, obtaining a maximum drag reduction rate and maximum energy saving rate of 38.6% and 31.4%, respectively. The results indicate that the pulsating flow effect can be characterized by the pulsation period and pressure gradient during acceleration and deceleration. Subsequently, two machine learning models are tested to predict the drag reduction rate. The results confirm that the machine learning model developed for predicting the time variation of the flow velocity and differential pressure with respect to the pump voltage can accurately predict the nonlinearity of pressure gradients. Therefore, using this model, the drag reduction effect can be estimated with high accuracy.     

Experimental and numerical analysis of cylindrical turbulators in a double pipe heat exchanger under turbulent flow conditions

In the present work, the use of cylindrical turbulators in a double pipe heat exchanger has been investigated. Cylindrical fin type of turbulators has been placed circumferentially separated by 90° on the outer side of an inner pipe at a regular pitch. Experimental studies were undertaken for different air flow rates in a turbulent regime whose Reynolds number range between 2500 and 10000. Heat transfer characteristics like Nu and friction factor have been experimentally determined. Parametric studies were conducted by changing the pitch and also the orientation of the turbulators. Nu and friction factor were found to increase as the pitch is reduced. A model with alternatively changed orientation outperformed others by exhibiting highest Nu and reduced friction factor.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

U型管内液柱振动的演示实验研究

根据实验结果，分析了影响U型管中液柱振动的各种因素，给出了获得好的演示效果的改进措施．     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

小长径比垂直管气液两相流动特性分析

实验观察了小长径比垂直上流管内流型及特点,并对管入口处的压力波动特性和系统的压差波动特性进行了试验研究.结果表明:小长径比(L/D)垂直管内流型表现为泡状流、塞状流、乳沫状流、环状流和液束环状流;分别增加管线中的气量、液量,或者同时增加气液流量,均会造成垂直管入口处压力波动的均值和最大压力的增加;压力信号的概率密度(PDF)大部分呈双峰分布,也存在单峰和多峰分布;差压信号的概率密度符合正态分布,其功率谱密度同压力信号相比具有频率波动范围宽、幅值小的特点.     

利用富铈混合稀土改善工业纯铝中富铁相形貌的研究

利用金相分析方法研究了富Ce混合稀土变质对含不同Fe量的工业纯铝的组织和其中富铁相形貌的影响。试验结果表明,随着Fe含量的增加,富铁相由弥散细小的颗粒状向短棒状、长针状转变;富Ce混合稀土变质使铝中的富铁相由长针状变为弥散细小的颗粒状。随着稀土含量的增加,-αAl晶粒逐渐细化,富铁相尺寸及数量逐渐减小。添加0.5%稀土时,-αAl晶粒细化效果最佳,而且富铁相呈细小颗粒状均匀分布在-αAl基体的晶界处。本文还对稀土改善富铁相的机制进行了分析。     

CreditRisk+模型下商业银行经济资本配置研究

对金融资产风险的度量与经济资本的分配应该体现分散化效应,传统的V aR方式不能保证分散化效应的次可加性.本文讨论了基于T a ilV aR这一新的风险度量与经济资本分配标准,并在违约率均值不变情况下,对C red itR isk+模型下的商业银行经济资本分配进行了实证分析.     

基于人工神经网络的商业银行信用风险模型

在对人工神经网络的基本原理进行简要介绍的基础上 ,着重对构建商业银行信用风险的人工神经网络模型进行了研究 ,实证结果表明 ,人工神经网模型具有很高的预测精度